Bosch GHO 18 V Operations Instructions download pdf (Page 21)

English | 21

Bosch Power Tools 1 609 929 N13 | (16.1.08)

Switch the machine on and guide the machine

with even feed over the surface to be planed.

To achieve high-grade surfaces, work only with

low feed and apply pressure on the centre of the

planer base plate.

When machining hard materials (e.g. hardwood)

as well as when utilising the maximum planer

width, set only low planing depths and reduce

planer feed, as required.

Excessive feed reduces the surface quality and

can lead to rapid clogging of the chip ejector.

Only sharp blades achieve good cutting capacity

and give the machine longer life.

Beveling Edges (see figure H)

The V-grooves in the front planer base plate allow

quick and easy beveling of workpiece edges. De-

pending on required bevel width, use the corre-

sponding V-groove. For this, place the planer

with the V-groove onto the edge of the workpiece

and guide it along the edge.

Planing with Parallel/Beveling Guide

(see figures E–G)

Mount the parallel guide 20 or beveling guide 24

to the machine using the corresponding fasten-

ing bolt 23. Depending on the application, mount

the rebating depth stop 27 with fastening bolt 26

to the machine.

Loosen the locking nut 22 and adjust the request-

ed rebating width on the scale 21. Tighten the

locking nut 22 again.

Adjust the requested rebating depth accordingly

with the rebating depth stop 27.

Carry out the planing procedure several times un-

til the requested rebating depth is reached.

Guide the planer applying sideward supporting

pressure.

Beveling with the Beveling Guide

When beveling rebates

and surfaces, adjust the

required slope angle

with the angle adjust-

ment 25.

Maintenance and Service

Maintenance and Cleaning

f Before any work on the machine (e. g. main-

tenance, changing the tool, etc.) as well as

during its transport and storage, lock the

On/Off switch in the off position. There is

danger of injury when the On/Off switch is un-

intentionally actuated.

f For safe and proper working, always keep

the machine and ventilation slots clean.

If the machine should fail despite the care taken

in manufacturing and testing procedures, repair

should be carried out by an after-sales service

centre for Bosch power tools.

In all correspondence and spare parts order,

please always include the 10-digit article number

given on the type plate of the machine.

Replacing the Drive Belt (see figures I–K)

Unscrew the screws 10 and take off the belt cov-

er 9. Remove the worn drive belt 28.

Before assembling a new drive belt 28, clean

both pulleys 29 and 30.

Place the new drive belt 28 on the small pulley 30

first and then work the drive belt 28 onto the

large pulley 29 by hand while rotating it.

Mount the belt cover 9 again and tighten the

screws 10.

Groove to be

used

Dimension a

(mm)

none 0

– 2.5

small 1.0 – 3.5

medium 2.0 – 4.0

large 2.5

– 5.0

OBJ_BUCH-639-001.book Page 21 Wednesday, January 16, 2008 3:29 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 117 118

Comments to this Manuals

No comments

Bosch GHO 18 V Operations Instructions Page 21

Comments to this Manuals

Related products and manuals for Cordless planers Bosch GHO 18 V