Bosch SRX53C15UC Installation Manual download pdf (Page 71)

Plumbing Preparation

Water Supply Shut Off Valve

Install an easily accessible shut-off valve (not supplied) in

the hot water supply line, as shown in Figure 7. All solder

connections must be made before the water line is

connected to the dishwasher.

Connecting the Hot Water Supply

There are two plastic corrugated hoses that exit the back

of the dishwasher. The larger hose, with the brass fitting

on the end, is the water supply hose to the dishwasher

(the other hose is the dishwasher drain hose). You will

need a 3” x 1

” (76 x 45mm) opening through the cabinet

to pass the dishwasher water supply line through toward

the shut off valve.

To connect the hot water supply:

1. Assemble the water supply adaptor fitting from the

parts bag onto the dishwasher water supply hose (see

Figure 7). This connection does not require Teflon

brand tape.

2. Pass the dishwasher water supply line with attached

adaptor through the opening toward the water shut off

valve. Take care not to allow the hose to kink or twist

behind the dishwasher.

3. Connect the dishwasher water supply line with adaptor

to the water shut off valve. You will need to use an

approved dishwasher water supply line with the correct

fittings for this connection. Always use the appropriate

seal when making plumbing connections.

NOTE: The end of the dishwasher water inlet hose is

heavy and will need to be supported. It is best to lay

the end on the cabinet floor as shown in Figure 7.

4. After all connections are made, turn on the hot water

and check for leaks.

Dishwasher

Water Inlet

Hose

Water

Shut Off

Valve

110-120V

Figure 7

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 105 106

No comments

Bosch SRX53C15UC Installation Manual Page 71