Bosch SRX53C15UC Installation Manual download pdf (Page 70)

INLET WATER CONNECTIONS

Plumbing Preparation

Avoid Scald Hazard

Do not perform any work on a charged hot water

line. Serious injury could result. Only qualified

plumbers should perform plumbing work. Do not

attempt any work on the dishwasher hot water

supply plumbing until you are certain the hot

water supply is shut off.

Hot Water Supply

The hot water heater should be set to deliver

approximately 120° F (49° C) water to the dishwasher.

Water that is too hot can cause some detergents to lose

effectiveness. Lower water temperatures will increase run

times. The hot water supply pressure must be between

15 - 145 psi (1 - 10 bar).

IMPORTANT NOTES:

· If using a solder joint instead of a compression fitting,

be sure to make all solder connections before connect-

ing the water supply line to the dishwasher.

· Make sure there are no sharp bends or kinks in the

water line that might restrict water flow.

· Always use the appropriate seal when making plumb-

ing connections.

· Before connecting the water supply line to the

dishwasher, flush the incoming water line for

approximately 5 minutes to clear any foreign material.

· Turn on the water supply and check for leaks after

connections are made.

· Do not use pipe sealant on compression fittings.

Temperatures required for soldering and sweating

will damage the dishwasher. If plumbing lines are

to be soldered or sweated, keep the heat

source at least 6 inches (152.4 mm) away from

the dishwasher.

WARNING

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 105 106

No comments

Bosch SRX53C15UC Installation Manual Page 70