'?.;@=<?A6;4
'
< .C<61 6;7B?F 3<99<D .99 @A.A2:2;A@ 612;A63621
/29<D/FA52( ' •@F:/<9
• "2C2? 963A A56@ @.D /F 4?.@=6;4 A52 /.@2
2
EA2;@6<;@ D52; A52F .?2 6; A52 2EA2;121
=<@6A6<;
• (;=9B42920A?600<?1.;1D6;1B= Use the hook
a
nd loop strap to hold the wrapped cord together.
•
"2C2? 963A A52 @.D /F 4?6==6;4 .;F <3 A52
:205.;6@:=.?A@ The saw may move and cause
severe injuries to your fingers or hands.
• '<.C<61/.086;7B?F5<91A52A<<909<@2A<F<B?
/<1FD52;963A6;4Bend your knees so you can lift
with your legs, not your back.
• "2C2?963AA<<9/F5<916;4@D6A055.;192 This may
cause serious damage to the tool.
• "2C2? 963A A52 :6A2? @.D /F A52 =<D2? 0<?1
Attempting to lift or carry the tool by the power cord
will damage the insulation and the wire connections,
resulting in electric shock or fire.
• $9.02 A52 @.D <; . 36?: 92C29 @B?3.02 D52?2
A52?26@=92;AF<3?<<:3<?5.;196;4.;1=?<=2?9F
@B==<?A6;4A52D<?8=6202
#" , 963A A56@ @.D /F A52 0.@A6; 0.??F 5.;192@
.A2.05@612<3A52/<AA<:<3A52/.@2<? A<=0.??F
5.;192
$?2=.?6;4'< 63A'52&.D
1. Set bevel angle at 0° and lock in place using the
bevel lock lever.
2. Rotate the table to either 45° or 0° and lock into
place using the miter lock knob.
3. Lock the saw head in the DOWN position with the
head assembly lock pin.
4. Slide the head assembly completely to the front
and engage the slide rail lock knob by tightening
the knob to the right (clockwise) (figure 20).
5. Check that each sliding base extension is in the
closed and locked position, (figure 20).
63AA52@.D/FA520.@A6;0.??F5.;192@
With the saw facing you and the head mitered to a
45˚, head assembly locked down, and the head in the
forward position with the slide rail knob tightened.
Grip both cast in carry handles located under the
base table extension (see figure 20). Continue to lift
and transport comfortably.
'<=.??F6;4
.;192
.@A;
.??F6;4
.;192
FIG. 20
.@A;
.??F6;4
.;192
&9612%.69
<08
EA2;@6<;@
<08
Comments to this Manuals