!.86;4.5<=BA
Note: For maximum chop cut capacity use chop/crown
lock as shown on page 22.
1. Slide the head assembly to the rear as far as it will go
(figure 35).
2. Tighten the slide rail lock knob.
3. Properly position workpiece. Make sure workpiece is
clamped firmly against the table and the fence. Use
clamping position that does not interfere with
operation. Before switching on, lower head assembly
to make sure clamp clears guard and head assembly.
2 .D.?2 <3 A52 =.A5 <3 A52 @.D
/9.12!.82.1?F?B;D6A5A52@.D
#33 /F 0<;1B0A6;4 . @6:B9.A21 0BAA6;4 0F092 .;1
</@2?C2A52=?<720A21=.A5<3A52@.D/9.1222=
5.;1@.A92.@A@6E6;052@.D.F3?<:A52=?<720A21
=.A5<3A52@.D/9.12
4. Activate the switch. Lower the head assembly and
make your cut.
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
5<=BA
&9612%.69
<08;</
&.D#=2?.A6<;@
FIG. 35
")% =B99 A52 @.D A<D.?1 F<B
1B?6;4.0BA The blade can suddenly
climb the workpiece causing KICKBACK.
!.86;4.&9612BA
1. Properly position workpiece. Make sure workpiece is
clamped firmly against the table and the fence.
Use clamping position that does not interfere with
operation. Before switching tool on, lower head
assembly to make sure clamp clears guard and head
assembly.
2. Loosen the slide rail lock knob.
2 .D.?2 <3 A52 =.A5 <3 A52 @.D
/9.12!.82.1?F?B;D6A5A52@.D
#33 /F 0<;1B0A6;4 . @6:B9.A21 0BAA6;4 0F092 .;1
</@2?C2A52=?<720A21=.A5<3A52@.D/9.1222=
5.;1@.A92.@A@6E6;052@.D.F3?<:A52=?<720A21
=.A5<3A52@.D/9.12
3. Grasp the switch handle and pull the head assembly
away from the fence, until the blade clears the
workpiece or to its maximum extension if blade
cannot clear the workpiece (figure 36).
4. Activate the switch. Lower the assembly all the way
down and cut through the edge of the workpiece.
5. Push (but do not force) the head assembly towards
the fence to the full rear position to complete the cut.
6. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
&9612BA
FIG. 36
*%""
!
*%""
!
*%""
!
Comments to this Manuals