Bosch CM12SD Use and Care Manual download pdf (Page 24)



(@6;4A52*<?8=62029.:=

This clamp easily secures a workpiece to the table or

base, figure 28.

. Insert the clamp’s knurled bar down into a clamp

post hole. There are two post holes located in the

base behind the fence. The knurled end must be in

the post at least 1/2".

2. Slide the clamp down until its rubber foot contacts

the workpiece.

3. Adjust the clamp height so it does not touch the

sliding fence.

4. Rotate the clamp’s knob until the workpiece is

firmly held in place.

5. Move saw head up and down and forward and

back to be sure it clears the clamp.

'52?2:.F/22EA?2:20<:=<B;1

0BA@ D52?2 09.:= 0.;;<A /2

B@21&B==<?AD<?8=6202D6A5F<B?5.;1<BA@612

A52 T"< .;1@U G<;2 < ;<A A?F A< 0BA @5<?A

=6202@ A5.A 0.;;<A /2 09.:=21 .;1 0.B@2 F<B?

5.;1A</26;A52T"<.;1@UG<;2

2 .D.?2 <3 A52 =.A5 <3A52 @.D

/9.12 !.82 . 1?F ?B; D6A5 A52

@.D#33/F0<;1B0A6;4.@6:B9.A210BAA6;40F092

.;1</@2?C2A52=?<720A21=.A5<3A52@.D/9.12

22=5.;1@.A92.@A@6E6;052@.D.F3?<:A52

=?<720A21=.A5<3A52@.D/9.12

Other hold-down devices such as C-clamps can be

used to hold the workpiece firmly against the table

and the fence. Make sure the clamps are clear of the

cutting path.

*<?8=6202

9.:=

FIG. 28

9.:=

<<A

9.:=

;</

$?2=.?6;43<?&.D#=2?.A6<;@

*<?8=6202&B==<?A

*%""

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 127 128

No comments

Bosch CM12SD Use and Care Manual Page 24