Bosch DIP-2042-4HD Installation Manual download pdf (Page 18)

Installation - first steps

DIVAR IP systems are shipped with a pre-installed Configuration

Wizard from factory.

Setup notes

By default all DIVAR IP systems are configured to obtain a valid

network address from DHCP server in the local network. In

small networks this task is usually performed by an internet

router. If there is no DHCP server in the network, DIVAR IP will

use the following network settings:

– IP Address: 192.168.0.200

– Subnet mask: 255.255.255.0

Notice!

We strongly recommend that you do not change any operating

system settings. Operating system access should only be used

for troubleshooting. Changes can result in malfunctioning of the

system.

Connecting the unit

DIVAR IP system is ready to go out of the box. The application

provides a simple to install and intuitive to use solution for

network surveillance systems.

Connecting the unit:

1. Connect the unit and the cameras to the network.

2. Connect the unit to the power supply.

3. Turn on the unit.

A series of scripts perform important setup tasks. This can

take several minutes. Do not turn off the computer.

Note: During this initial setup the system LED is blinking.

After the system is ready for operation, the system LED

stops blinking. The web based wizard pages of the DIVAR IP

5.1

5.2

18 en | Installation - first steps DIVAR IP 2000

2014.07 | V1 | DOC Bosch Sicherheitssysteme GmbH

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

No comments

Bosch DIP-2042-4HD Installation Manual Page 18