Bosch HXS59AI20Q Instruction Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Appliance door en
29
Attaching the door
Reattach the oven door in the reverse sequence to
removal.
1. When attaching the oven door, ensure that both
hinges are inserted straight into the opening
(figure A).
2. The notch on the hinge must engage on both sides
(figure B).
3. Fold back both locking
levers (figure C). Close the oven door.
:Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the aftersales
service.
Removing and refitting the door panels
The glass panels can be removed from the oven door
to allow more thorough cleaning.
Removal
1. Removing the oven door See the section Removing
the oven door
. Lay the oven door on a cloth with the
handle facing downwards.
2. Remove the cover from the top of the oven door. To
do this, press with your fingers on the left and right-
hand side. Pull out the cover (Fig. A).
3. Raise the top panel and pull it out (Fig. B).
Clean the panels with glass cleaner and a soft cloth.
:Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting
1. Hold the top glass panel firmly by the sides and slide
it in towards the back at an angle. The panel must
be inserted into the openings on the lower side. The
smooth surface must face outwards, while the
roughened side must be on the inside. (Fig. A).
2. Place the cover on the top of the oven door and
press in place. Make sure that the grooves along the
sides lock into position.
3. Refitting the oven door See the section Refitting the
oven door
.
Do not use the oven again until the panels have been
correctly fitted.
Upper glass cover
Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.
%
$
&
%$
$
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Comments to this Manuals

No comments