Bosch OS50VC Use and Care Manual download pdf (Page 9)

-9-

Notes:

• Make sure that SheetLoc™ System’s front

clamp lever is latched, even when PSA

abrasive sheets are used.

• Remove PSA sheets soon after completing

each sanding operation in order to prevent

the adhesive from creating a hardened

bond with the backing pad.

REMOVING PSA ABRASIVE SHEETS

To remove, lift an edge of accessory with your

fingernail and peel it off the backing pad.

Note: If PSA paper is accide

ntally left on the

pad, the best way to remove it is to sand for a

few minutes to soften the adhesive backing.

PUNCH PLATE

After the paper has been installed, it will be

necessary to punch holes into the paper using

the punch plate provided with your sander.

Align sander base with punch plate and push

down on sander until punch plate pierces the

paper. Then remove punch plate from sander

(Fig. 6).

D

FIG. 6

MICROFILTER DUST CANISTER

The integral dust extraction system collects

sanding dust in canister supplied with your

sander. For maximum efficiency, the dust

canister should be emptied frequently during

operation.

Your tool is equipped with

a dust canister, empty it

frequently, after completion of sanding and

before storing the sander. Be extremely

careful of dust disposal, materials in fine

particle form may b

e explosive. Do not throw

sanding dust on an open fire. Combustion

from mixture of varnishes, lacquers,

polyurethane, oil or water with dust particles

can occur if there is a static discharge, spark

introduced in the box, or excessive heat.

REMOVING AND INSTALLING

DUST CANISTER

To remove dust canister: Twist the dust

canister and simply pull away from the tool

(Fig. 7).

To install dust canister: align dust p

ort with

hole in canister and push canister onto tool

until it locks into place (Fig. 8).

Dust Collection

!

WARNING

2

1

FIG. 7

I

FIG. 8

DUST

CANISTER

DUST PORT

DUST

CANISTER

PUNCH

PLATE

BM 2609932873 11-12_BM 2609932873 11-12.qxp 11/27/12 10:48 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comments to this Manuals

No comments