Bosch B26FT70SNS User Manual download pdf (Page 6)

en-us

6

Installation

Transport and installation

The appliance is heavy and must be

secured during transport and

installation.

WARNING

Risk of injury!

The appliance is very heavy. It can

fall over and cause serious injuries

during transport and installation. At

least two people are required to

install the appliance safely. Keep

the refrigerator doors closed until

the appliance is upright and level at

the installation location.

Installation location

WARNING

Risk of explosion!

Do not install the appliance near

explosive or flammable

substances.

NOTICE

Do not install the appliance

outdoors.

The installation location should be

dry and should not be exposed to

frost.

The best installation location is a dry,

well ventilated room. The installation

location should neither be exposed to

direct sunlight nor should it be near a

heat source, such as a stove, radiator,

etc. If installation next to a heat source

is unavoidable, use a suitable

insulating plate or observe the

following minimum distances to the

heat source:

S 1

1/4

I

(3 cm) to electric or gas

stoves.

S 11

3/16

I

(30 cm) to oil or solid fuel

stoves.

If installing the refrigerator next to

another refrigerator/freezer, there

must be a minimum clearance of 1”

(25 mm) between the appliances to

prevent condensation.

If a panel or cupboard is installed

above the appliance, ensure to leave

a 13/32

I

(10 mm) gap so that the

appliance can be pulled out of the

recess if required.

The air heated at the back of the

appliance must be allowed to escape

unhindered.

To ensure that the doors can open all

the way, maintain the lateral minimum

clearances when installing the

appliance in a corner or recess (see

section on ”Appliance and installation

dimensions”).

If the depth of the adjacent kitchen

equipment exceeds 29

1/8

I

(75 cm),

maintain the minimum lateral

clearances in order to utilize the full

door opening angle (see section

”Door opening angle”).

Subsurface

NOTICE

The appliance is very heavy.

The floor on which the appliance is

to be installed must be rigid.

Reinforce the floor, if necessary.

Weight of appliance when empty:

Basic model 324 lb

(147 kg)

Ventilation

Never cover the ventilation openings

on the front base panel or rear cover

plate.

This forces the appliance to work

harder, increasing its power

consumption.

1 2 3 4 5 6 7 8 9 10 11 ... 77 78

Comments to this Manuals

No comments