Bosch B36BT830NS User Manual download pdf (Page 23)

Special installation

Preparing to connect the water

(only for appliances which require a water connection)

Note:

Turn off the main water tap to prevent damage caused

by leaking water.

1. Attach the water line to the shut-off valve according

to the instructions supplied by the manufacturer of

the ice maker installation kit.

2. Install the water line.

Always observe the indicated dimensions to prevent

damage to the water line when pushing in the

appliance.

Connecting the water to the appliance

Note:

When bending the water line, do not kink it, otherwise

there is a risk of leaks and water damage.

1. Remove the cap from the appliance connection (1.).

2. Bend the water line according to the location of the

connection on the appliance (2.).

3. Push the union nut and seal onto the water line.

4. Push the end of the water line into the appliance

connection and screw on the union nut (3.).

Tighten hand-tight.

5. Using the open-ended wrench, tighten the union nut.

Do not overturn!

6. Push back the water line into the guard tube as far

as possible (4.).

7. Open the shut-off valve and main water tap.

8. Check the connection on the shut-off valve and on

the appliance for leaks.

9. Close the shut-off valve.

Adjusting the door opening angle

Depending on the installation situation, it may be

necessary to adjust the door opening angle. A door

opening angle of 115° has been set at the factory.

To adjust the door opening angle to 90°:

1. Open door to 90°.

2. Insert the banking pin through the boreholes which

are now vertically aligned and drive in with

a hammer.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

No comments

Bosch B36BT830NS User Manual Page 23