Bosch LTC 8500 Instruction Manual download pdf (Page 55)

Switcher Commands

EN | 45

Keyboard Log-off Procedure

If the log-in feature has not been enabled, this action is not applicable. If the feature

has been enabled, press: User Log-off [User, then OFF].

Any priority based remote control or monitor locks made by the user will automati-

cally be released at time of log-off.

16.3 Switcher Commands

•Camera Selection: Enter a camera number for viewing and press [Enter]. (The

keyboard default mode is the camera mode).

•Monitor Selection: Press MON [Monitor], enter a monitor number and press

[Enter].

16.4 Controlling Camera Movement

General

Camera positioning is controlled via an eight-way joystick on the right-hand side of

the keyboard. This joystick controls the camera pan/tilt (if equipped), moves the

camera up, down, left, right, or diagonally. Moving the joystick up and to the right

simultaneously moves the camera in a diagonal direction.

Rotate the joystick knob to control the zoom lens in or out. The direction of its

response depends on the camera/lens model and certain system configuration set-

tings that are determined at installation. Up to four pan/tilt/zoom commands may

be sent to a remote camera site at a time (Example - Zoom In, Focus Far, Pan Left,

and Tilt Down). All three (3) zoom lens functions can also be sent simultaneously

(Example - Zoom Out, Focus Near, Iris Open).

Focus and Iris Lens Control

The lens control buttons are on the right side of the keyboard. The camera's zoom

lens (if equipped) is controlled to focus near or far, and open or close the iris (if the

lens supports manual iris operation).

Lock or Unlock Control of a Camera

When using IntuiKey keyboards, press [Device Lockout], located on the main Alle-

giant menu screen to enter a menu screen for these options. With the LTC 8555

Series keyboards, press [Lock], then [ON] to lock a camera. To unlock a camera,

press [OFF]. If the camera to be locked is not the one currently being viewed, enter

the camera number via the numeric keyboard (but do not press [Enter]) before

pressing [Lock].

If the Status option is enabled, the section of the onscreen overlay between the cam-

era number and the time shows

, indicating the camera is locked. Activating a

camera lock immediately prevents other operators (unless they have a higher prior-

ity) from controlling the locked pan/tilt/zoom camera. Remember to unlock the

camera when finished so other operators can access it.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 103 104

No comments

Bosch LTC 8500 Instruction Manual Page 55