Bosch DIP-7082-8HD Installation Guide download pdf (Page 14)

Installing the outer rails to the rack

Outer rails attach to the rack and hold the chassis in place. The outer rails extend between 30

inches and 33 inches.

To install the outer rails to the rack:

1. Secure the back end of the outer rail to the rack, using the screws provided.

2. Press the button where the two outer rails are joined to retract the smaller outer rail.

3. Hang the hooks of the rails onto the rack holes and if desired, use screws to secure the

front of the outer rail onto the rack.

4. Repeat steps 1-3 for the remaining outer rail.

Locking Tabs

Both chassis rails have a locking tab, which serves two functions. The first is to lock the

system into place when installed and pushed fully into the rack, which is its normal position.

Secondly, these tabs also lock the system in place when fully extended from the rack. This

prevents the system from coming completely out of the rack when you pull it out for servicing.

Installing the chassis into the rack

To install the chassis into a rack:

1. Extend the outer rails as illustrated above.

2. Align the inner rails of the chassis with the outer rails on the rack.

3. Slide the inner rails into the outer rails, keeping the pressure even on both sides. When

the chassis has been pushed completely into the rack, it should click into the locked

position.

4. Optional screws may be used to secure the to hold the front of the chassis to the rack.

3.4.3

3.4.4

14 en | System setup - hardware DIVAR IP 7000 2U

2014.01 | V3 | DOC Quick Installation Guide Bosch Sicherheitssysteme GmbH

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

No comments

Bosch DIP-7082-8HD Installation Guide Page 14