Bosch GWS 6-100 (E) Specifications download pdf (Page 31)

32 | English

1 609 929 L32 | (3.3.08) Bosch Power Tools

Speed preselection (GWS 6-100 E/GWS 6-115 E/GWS 6-125 E/GWS 850 CE)

The required speed can be preselected with the thumbwheel 3 (also while running).

The data in the following table are recommended values.

Working Advice

f Clamp the workpiece if it does not remain

stationary due to its own weight.

f Do not strain the machine so heavily that it

comes to a standstill.

f Grinding and cutting discs become very hot

while working; do not touch until they have

cooled.

Rough Grinding

f Never use a cutting disc for roughing.

The best roughing results are achieved when

setting the machine at an angle of 30° to 40°.

Move the machine back and forth with moderate

pressure. In this manner, the workpiece will not

become too hot, does not discolour and no

grooves are formed.

Flap Disc

With the flap disc (accessory), curved surfaces

and profiles can be worked.

Flap discs have a considerably higher service

life, lower noise levels and lower sanding tem-

peratures than conventional sanding sheets.

Cutting Metal

f For cutting metal, always work with the pro-

tection guard for cutting 12.

When cutting, work with moderate feed, adapt-

ed to the material being cut. Do not exert pres-

sure onto the cutting disc, tilt or oscillate the

machine.

Do not reduce the speed of running down cut-

ting discs by applying sideward pressure.

The machine must

always work in an

up-grinding mo-

tion. Otherwise,

the danger exists

of it being pushed

uncontrolled out

of the cut.

When cutting pro-

files and square

bar, it is best to

start at the small-

est cross section.

Cutting Stone

f For cutting stone, always work with the cut-

ting guide with dust extraction protection

guard 19.

f The machine may be used only for dry cut-

ting/grinding.

For cutting stone, it is best to use a diamond

cutting disc. As a safety measure against jam-

ming, the cutting guide with dust extraction pro-

tection guard 19 must be used.

Operate the machine only with dust extraction

and additionally wear a dust protection mask.

The vacuum cleaner must be approved for the

extraction of masonry dust. Bosch provides suit-

able vacuum cleaners.

Material Application Accessory Thumbwheel

Position

Metal Removing paint Sanding disc 2

– 3

Wood, metall Brushing, rust removal Cup brush, sanding disc 3

Metal, masonry Sanding Sanding disc 4

– 6

Metal Rough grinding Sanding disc 6

Masonry, stone Cutting Cutting disc and cutting guide

(Cutting masonry/stone is permitted

only with use of the cutting guide)

OBJ_DOKU-2905-002.fm Page 32 Monday, March 3, 2008 12:56 PM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 193 194

Comments to this Manuals

No comments

Bosch GWS 6-100 (E) Specifications Page 31

Comments to this Manuals

Related products and manuals for Straight grinders Bosch GWS 6-100 (E)