i65 R
Crankcase,crankshaft
Z/
Dismantlingthe crankcase
Empty the fuel tank.
Clamp the clearing saw in fixture No. 5025103-01,
Remove the following:
Cylinder casing, starter, carburetor, cylinder and piston.
The throttle control cable need not be removed.
Fig 7:3
Back off the three screws securing the sealing ring hol-
der and remove the holder. Note the O-ring located in-
side the sealing ring holder.
Remove the ignition system.
Fig 7:1
Back off the four screws in the clutch housing and sepa-
rate the crankcase from the drive shaft, if necessary by
striking it lightly with a plastic mallet.
Fig 7:4
Fig 7:2
Remove the starter and fit holdfast No. 5025025-01 to
the flywheel.
Remove the centrifugal clutch (left-hand thread),
Note the shim inside the clutch,
Back off the five screws holding the crankcase halves
together.
Heat the bearing seats carefully to a temperature of
about 130°C with a blowlamp, They should be heated
evenly all round to avoid heat stresses,
Separate the crankcase halves by tapping them careful-
ly with a plastic mallet.
Remove the ball bearings from the crankshaft, using a
special ball bearing puller.
7:1
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Comments to this Manuals