Bosch DIE 165 R User Manual download pdf (Page 33)

Transmissionsystem

flu

When fitting the new spring, check that its engagement

point is opposite a centrifugal weight.

Do not overload the spring on assembly.

Anglegear

Dismantling

Mount the clearing saw in fixture No. 5025103-01.

Fig 11:5

Lock the angle gear by inserting a suitable punch (inclu-

ded in the saw toolkit) through the hole in the gear hous-

ing.

Back off the blade nut (left-hand thread) and remove the

support flange, saw blade and driver.

Fig 11:6

Back off the five blade guard screws and remove the

guard.

Back off the two angle gear clamping screws and the

stop screw (see Fig. 10:9).

Withdraw the angle gear from the drive shaft tube.

Remove the oil filler plug and drain off any remaining oil

in the gear housing.

Removalof lowerbearinghousing

andgearshaft

Heat the angle gear with a blowlamp to approx. 130”C.

Clamp the angle gear in a vice with soft jaws.

Fit puller No, 5025065-01. Prevent the shaft from rotat-

ing by means of an adjustable spanner and tighten the

puller screw hard. Withdraw the bearing housing from

the gear housing by means of the puller.

Removalof upperbearinghousing

Fig 11:8

Remove the locking screw.

Fit extractor No. 5025063-01 and withdraw the bearing

housing from the gear housing.

11:2

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 28 29 30 31 32 33 34 35

No comments

Bosch DIE 165 R User Manual Page 33