D9412GV2/D7412GV2 | Operation and Installation Guide | 9.0 Off-Board Points
.
Bosch Security Systems, Inc. | 5/05 | F01U003641B 43
A D8128D OctoPOPIT can be installed up
to 61 m (200 ft.) from the control panel.
2. Connect the D8128D to the control panel:
• Wire the D8128D to the terminal strip on the
side of the POPEX Module (), or
• Connect the D8128D using the Molex
®
connectors (P1 and P2). Refer to Using Molex®
Connectors on page 46.
Caution - AC induction: Avoid installing
Zonex data wires and Zonex input (sensor
loop) wires around any AC conduit, wiring,
or electrical devices that emit fields of
electromagnetic interference (EMI).
Using the Terminal Strip
Refer to Table 17, Figure 16 on page 44, and Figure 17
on page 45 when using the terminal strip to connect the
D8128D OctoPOPIT to the control panel.
Table 17: Terminal Strip Connections
D8128D D9412GV2 D7412GV2
Common Terminal 23 Terminal 23
Out Zonex 1 = Terminal 27
Zonex 2 = Terminal 25
Terminal 27
In Zonex 1 = Terminal 28
Zonex 2 = Terminal 26
Terminal 28
+12 V Terminal 24 Terminal 24
Comments to this Manuals