Bosch FPD-7024 User Manual download pdf (Page 27)

Warning!

Before the circuit board is installed, connect the supplied ground wires between the door and

the enclosure and from the transformer to the enclosure using the supplied nuts. Both

grounds connect to the stud in the enclosure to the left of the circuit board.

For installation illustrations, see the figures for Enclosue installation, 26 and for Standoff and

support post installation, 27.

1. Insert the three support posts in the enclosure’s retainer holes.

2. Press the 1/8 in. nylon standoffs (P/N: F01U034705) into the retainer holes.

3. Slide the top of the control panel onto the retainer tabs (the slots under the top of the

frame). When the control panel is in the retainer tabs, it rests on the posts.

4. Secure the bottom of the circuit board by inserting and tightening the screws at the two

bottom corners through the support posts and the retainer holes.

For installing standoffs and support posts, see the following figure:

Figure 4.4: Standoff and support post installation

1 1/8 in. nylon standoff 4 Corner of circuit board

2 Retainer holes 5 Support post

3 Support post assembly 6 Retainer hole in enclosure

Installing optional equipment

Two expansion options connect directly to the control panel, and are automatically detected

and supervised when the control panel is powered:

– FPC-7034 Four Point Expander

– D7039 Multiplex Expansion Module

When the control panel is powered after installing one of these options, the control panel

displays one of the following windows:

4Z EXP DETECTED

PRESS BACK KEY

MUX DETECTED

PRESS BACK KEY

Press the [*/BACK] key to confirm the installation of the device and automatically set it up for

supervision.

4.4

Fire Alarm Control Panels Installation | en 27

Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 121 122

No comments

Bosch FPD-7024 User Manual Page 27