Bosch 1295D User Manual download pdf (Page 7)

-7-

Operating Instructions

ROCKER “ON/OFF” SWITCH

(Models 1295D & 1295DP)

TO TURN THE TOOL "ON" depress the upper

portion of the dust-protected switch to the

number “1” position.

TO TURN THE TOOL "OFF": depress the

lower portion of the switch to the number “0”

position.

THREE-POSITION ROCKER SWITCH WITH

SWIFTSAND™ SETTING (MODEL 1295DH)

Your tool is equipped with a three-position

switch which allows normal surface finishing

or faster stock removal with the SwiftSand™

option.

TO TURN THE TOOL “ON for normal finishing,

depress the lower portion of the dust-

protected switch to the number (1) position.

TO THE TURN THE TOOL “ON in the

SwiftSand™ (high removal) setting, depress

the upper portion of the switch to the number

(2) position.

TO TURN THE TOOL “OFF from either setting

move the switch to the center number “0”

position.

Setting Applications

1 Normal surface finishing for wood,

plastics, solid-surfacing and

composites.

2 SwiftSand™ setting for solid wood,

fast stock removal, paint removal, fast

blending of joints or repairs in solid

surfacing.

Metal sanding and finishing,chipboard

course sanding of wood and other

surfaces.

Finish removal, light polishing or

scratch blending.

BACKING PAD INSTALLATION

The random orbit sander is equipped with a

backing pad of medium hardness, which is

suitable for general service. Harder and softer

pads are available for other purposes, and in

general are used as follows;

Soft pad - Polishing or sanding large or curved

surfaces.

Medium pad - All purpose general sanding

and polishing.

Hard pad - Heavy sanding on flat surfaces,

especially with coarser abrasives.

To change backing pad, hold pad firmly and

turn screw counterclockwise with 5mm allen

wrench provided. Remove old pad, and place

new pad over locating pins on drive spindle.

Replace screw and securely tighten in a

clockwise direction with the allen wrench.

Damaged or worn backing pads must be

replaced immediately.

BACKING PAD DAMPER

Your tool is equipped with an integrated

backing pad damper ring. This damper

reduces the no-load speed, which helps

prevent accidental marking of the workpiece

surface and provides uniform finishing.

NOTE: If you notice steadily increasing no-

load speed, this indicates that the damper ring

is worn and needs to be replaced.

To replace damper ring, remove backing pad

as described in “Backing Pad Installation” and

remove worn damper ring by pulling firmly out

of locating groove. Loosen the two screws on

shroud just enough so you can separate

shroud approximately 1/4 inch. Align locating

bumps on damper ring with cut outs in shroud

and depress ring with thumbs until shroud

seats into groove completely around ring, then

tighten screws.

IMPORTANT: Ring should not have bends or

ripples when correctly seated.

Apply a thin film of light grease to top side of

backing pad where the damper ring makes

contact, reassemble backing pad and firmly

tighten screw.

DAMPER RING

SHROUD

BACKING

PAD

LOCATING

BUMPS ON

UNDERSIDE

OF DAMPER

RING

BM 2610968990 11/00 11/14/00 12:26 PM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments