Bosch CM8S Use and Care Manual download pdf (Page 18)



< .C<61 =<@@6/92 6;7B?F

16@0<;;20A =9B4 3?<: =<D2?

@<B?02 /23<?2 =2?3<?:6;4 .;F .@@2:/9F

.17B@A:2;A<??2=.6?

2?3;@2?A17B@A:2;A

The kerf inserts should be adjusted close to the

blade, but without touching the blade, to avoid tear-

out on the bottom of the workpiece.

1. Hold the saw head assembly down and push in the

head assembly lock pin (item 36 – page 9) to keep

the saw in the DOWN position.

2. Loosen the four kerf screws using a 4mm Hex key,

(figure 15).

3. Adjust the kerf inserts as close to the blade (teeth)

as possible without touching the blade.

4. Tighten the kerf screws.

NOTE: At extreme bevel angles, the saw blade may

slightly cut into kerf insert.

52086;4O2C29&A<=&2AA6;4

1. Hold the saw head assembly down and push in

the head assembly lock pin (item 36 – page 9) to

keep the saw in the DOWN position.

2. Slide the head assembly completely to the back

and engage the slide rail lock knob by tightening

the knob to the right (clockwise) (item 25 – page 9).

3. Rotate the table to the 0° miter position.

4. Pull the bevel lock lever forward to unlock the

head assembly.

5. Tilt the saw assembly to the left

(counterclockwise), then rotate to the right

(clockwise) until you feel the stop in the vertical

position. This is where the saw is currently set for

0° bevel cut.

6. Use a combination square to check that the blade

is 90° (square) to the table. Place the square’s

ruler edge against the table and slide it to contact

the blade with the vertical side of the square’s

head (see figure 16).

7. Check that the saw blade’s plate (not teeth) is

touching the square’s 90° side. If the saw blade’s

plate is not in full contact with the square’s body

90° side, follow the “Calibrating Blade at 0º Bevel”

procedures.

O2C29&A<=

*%""

FIG. 16

FIG. 15

2?3

&0?2D@

17B@A:2;A@

2?3;@2?A

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 131 132

Comments to this Manuals

No comments

Bosch CM8S Use and Care Manual Page 18

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM8S