Bosch CM8S Use and Care Manual download pdf (Page 25)



(@6;4A52*<?8=62029.:=

This clamp easily secures a workpiece to the table or

base, figure 29.

. Insert the clamp’s knurled bar down into a clamp

post hole. there are two post holes located in the

base behind the fence. The knurled end must be in

the post at least 1/2".

The 60˚ Auxiliary Clamp Hole is used to clamp

material at angles from 55˚ to 60˚ right (figure 30).

For installation instructions see page 12.

2. Slide the clamp down until its rubber foot contacts

the workpiece.

3. Adjust the clamp height so it does not touch the

sliding fence.

4. Rotate the clamp’s knob until the workpiece is

firmly held in place.

5. Move saw head up and down and forward and

back to be sure it clears the clamp.

'52?2:.F/22EA?2:20<:=<B;1

0BA@ D52?2 09.:= 0.;;<A /2

B@21&B==<?AD<?8=6202D6A5F<B?5.;1<BA@612

A52 T"< .;1@U G<;2 < ;<A A?F A< 0BA @5<?A

=6202@ A5.A 0.;;<A /2 09.:=21 .;1 0.B@2 F<B?

5.;1A</26;A52T"<.;1@UG<;2

2 .D.?2 <3 A52=.A5 <3 A52 @.D

/9.12 !.82 . 1?F ?B; D6A5 A52

@.D#33/F0<;1B0A6;4.@6:B9.A210BAA6;40F092

.;1</@2?C2A52=?<720A21=.A5<3A52@.D/9.12

22=5.;1@.A92.@A@6E6;052@.D.F3?<:A52

=?<720A21=.A5<3A52@.D/9.12

Other hold-down devices such as C-clamps can be

used to hold the workpiece firmly against the table

and the fence. Make sure the clamps are clear of the

cutting path.

*<?8=6202

9.:=

FIG. 29

9.:=

<<A

9.:=

;</

$?2=.?6;43<?&.D#=2?.A6<;@

*<?8=6202&B==<?A

*%""

FIG. 30



BE696.?F

9.:=<92

*%""

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 131 132

Comments to this Manuals

No comments

Bosch CM8S Use and Care Manual Page 25

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM8S