Bosch Flasher-PRO User Manual download pdf (Page 6)

Flasher-PRO User’s Manual | August 2008 Robert Bosch LLC

Setting Up the Flasher-PRO | Flasher-PRO | 5

Setting Up the Flasher-PRO

Powering Flasher-PRO

First, determine how the Flasher-PRO will receive power:

1. Vehicle power: The optional MVCI to OBD-II cable provides power to

the Flasher-PRO from a vehicle. Most vehicles built after 1996 have

an OBD-II port somewhere under the dash on the driver’s side, as

specied in SAE J1962.

2. Bench top power supply: When using the Flasher-PRO on a bench,

put power on pin 16 (VBATT) and ground on pin 5 (Signal Ground).

When Flasher-PRO is rst powered-on, the lights will cycle through a

self-test procedure. Remember that the Flasher-PRO does not receive

power from your PC’s Ethernet or USB ports.

Connecting and Conguring Flasher-PRO

Second, connect the Flasher-PRO to your PC:

Using USB

The Flasher-PRO is powered from the vehicle connector, so it will have

to be connected to a vehicle or powered from an external power supply

to use USB. Once powered, connect your PC to the Flasher-PRO thru

USB to install the drivers.

1. Once connected, you

will be prompted from

windows with new

hardware found.

2. Select Install from a list

or specic location. Click

browse and point to

the CD drive, under the

Drivers-USB folder. If your

CD-ROM is Drive letter E,

the path would be

e:\Drivers-USB.

3. Follow the process; it will install the USB drivers.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Bosch Flasher-PRO User Manual Page 6