Bosch D9210C Owner's Manual download pdf (Page 15)

D9412GV4/D7412GV4/D7212GV4 | Owner's Manual Supplement

Bosch Security Systems, Inc. | 9/11 | F01U245224-02 15

You can use the function list in place of steps 2 and 3 to

start this function.

1. Press the [MENU] key to enter the function list.

2. Press [NEXT] repeatedly until you reach the DOOR

CTRL? prompt.

3. Press [ENT].

4. The first sub-function that appears is CYCLE DOOR?. You can

cycle through the three sub-functions by pressing [PREV] and

[NEXT].

On a D1260 Keypad

1. Ensure that the display shows idle disarmed text.

2. Press the [COMMAND] key. The display shows *System

Command*.

3. Press [4] and [6].

You can use the function list in place of steps 2 and 3 to

start this function.

1. Press the Menu softkey to enter the function list.

2. Press the Next softkey repeatedly until you reach the

Door Control? softkey.

3. Press the Door Control ? softkey.

4. All authorized door control function sub-functions are listed.

Press the corresponding softkey to enter the sub-function.

2.10.3 Cycle Door?

1. To unlock an access door briefly and allow a person into an

area, press [ENT] at the Cycle Door? prompt.

The display shows CYCLE 1 2 3 4 5 6 7 8 if all doors are in

a normal state and available. If a door is not in a normal state,

the number of the door is replaced with one of the symbols

indicated in Table 3.

Depending on your keypad, the operations in this

section are the same, but the keypad display and keys

are slightly different.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Bosch D9210C Owner's Manual Page 15