Bosch D621 Series User's Guide download pdf (Page 42)

D621 Series | User's Guide | System Test (Cmd 41)

Bosch Security Systems | 8/04 | 42

System Test (Cmd 41)

o I can perform this command.

o I cannot perform this command.

The System Test command allows you to ensure your system

is operating correctly. Your security company configures the

system test for you.

My system test includes:

System Bell

Battery

System Strobe

Phone Line

If any of these components fails to test, contact your security

company for assistance. Be sure to contact your security

company before you begin the system test if a phone line is

connected.

1. Make sure the system is turned off (All and Part indicators

are off).

2. Press [Cmd] [4] [1]. The keypad may prompt you to enter

a valid passcode by flashing the Cmd indicator.

3. Enter your passcode if necessary. The system starts the

test. As each test is underway, the corresponding point

indicator lights. Refer to Table 8.

Table 8: System Test Lights

Point # Testing

1 Bell

2 Strobe (may take up to 20 min.)*

3 Backup Battery (may take 4 min.)*

4 Communications (may take up to 10 min.)*

* To skip to the next text, press the [*] key.

When testing the bell and strobe, check for

bell/strobe activation. The LED testing status

does not indicate bell/strobe test failure (point

indicator does not flash fast upon test failure).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 61 62

No comments

Bosch D621 Series User's Guide Page 42