Bosch D621 Series User's Guide download pdf (Page 52)

D621 Series | User's Guide | Remote Arming With Telephone, Area 1

Bosch Security Systems | 8/04 | 52

Remote Arming With Telephone,

Area 1

o I can perform this command.

o I cannot perform this command.

This function controls the built-in telephone arming feature

for Area 1. When enabled, the panel answers the phone on

the programmed ring count.

When the panel answers the phone, it

• sounds three beeps and starts the handshake tone for

remote programming if the panel is All or Part On.

• sounds one short beep, waits approximately 3 seconds,

and then sounds one long beep if the panel is off. Press

and hold the [5] key* for two seconds immediately after

the first short arming beep and before the long beep

begins.

• arms if it detects a [5] key press from the telephone (All

On with Delay, faulted points are force-armed). The panel

sounds three beeps (new armed state) and then hangs up.

* If arming from a cell phone, quickly press the [5] key

three times. If pressing and holding the [5] key for 2

seconds from a house (land-line) phone does not produce

a tone long enough to arm Area 1, retry by quickly

pressing the [5] key three times.

Remotely disarming the panel cannot be done with a

telephone.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 61 62

No comments

Bosch D621 Series User's Guide Page 52