Bosch TS2000 User Manual download pdf (Page 7)

For Mounting Other Table Saws

Important: Before mounting a DeWalt,

Craftsman, Makita, Hitachi, or Ridgid table

saw, insert two (2) 8mm x 50mm Phillips

head screws through “B*” hole locations and

tighten using 8mm lock nuts.

1. Using the diagram below, locate the

correct mounting holes for the table saw

being used and position saw on stand

accordingly.

For use with Hitachi Table Saw:

If your TS2000 stand does not have "H"

holes, you will need to drill holes. Place

the saw over the center of the opening and

make pencil marks (through the L-shaped

bracket holes) on the table top mounting

plates. Remove saw and drill four (4) 5/16"

diameter holes through the mounting

plates.

For use with Ridgid Table Saw:

Locate the four “R” holes in the two

mounting plates and drill four (4) 3/8”

diameter holes completely through the

stand’s frame.

2. Mount the table saw using the appropriate

mounting hardware for your table saw

model.

-7-

Mounting

Table Saw Models

Holes

Bosch 4100/4000 B

Dewalt DW744 D

Craftsman 21830 C

Makita 2704 M

Hitachi C10RA2** H

Ridgid TS2400LS** R

**See instructions.

FIG. H

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments