Bosch DS7400XiV4-EXP User Manual download pdf (Page 11)

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 11

Bosch Security Systems | 6/05 | 4998154961B

6.1.5 Maximum Security Arming

Maximum security arming is used when no one is still in the building, all zones are to be armed, an exit delay is

in effect, but no entry delay is in effect so an alarm does occur upon entry.

The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green

LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section

6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).

Table 7: Maximum Security Arming

Equipment Command Sequence What Happens What To Do

Text Keypad LED

Keypad

[PIN][No Entry][On] • The red Armed LED flashes.

• “Armed Instant” is displayed. *

• “Exit Now” is displayed during the exit-

delay period. *

• A single beep sounds.

• The red Armed LED lights steady when

the exit-delay period ends.

• All zones are armed.

• Exit during the exit-delay

period.

• Violating any zone after the

exit-delay period ends

triggers an instant alarm.

RF3341 Keypad [PIN][#][5] • The LED flashes indicating a signal was

sent to your security system.

• All zones are armed.

• Exit during the exit-delay

period.

• Violating any zone after the

exit-delay period ends

triggers an instant alarm.

RF3332/RF3332E,

RF3334/RF3334E

Not applicable

* Text Keypad only

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Bosch DS7400XiV4-EXP User Manual Page 11