Bosch DS7400XiV4-EXP User Manual download pdf (Page 12)

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 12

Bosch Security Systems | 6/05 | 4998154961B

6.1.6 Normal Disarming

Please read Section 7.0 Emergency Procedures on page 19 before you are confronted with an emergency event. If you

entered the building through a perimeter door, you might hear a steady entry alert tone from the wired keypads.

If so, disarm according to the chart below.

If an alarm occurred sometime before your arrival, one or more of these happens:

• The bells and sirens sound.

• The wired keypads issue a pulsed tone during the entry delay instead of the usual steady tone.

• The red Armed LED on any LED keypad flashes.

• The red Armed LED on any text keypad flashes and “Zone Alarm” is displayed.

If the alarm is not yet investigated, do not enter the building unless accompanied by the appropriate

Emergency Services’ personnel.

Table 8: Normal Disarming

Equipment Command Sequence What Happens What To Do

Text Keypad LED

Keypad

[PIN][Off] • The red Armed LED turns off.

• All sounders are silenced.

• All zones are disarmed.

• A single beep sounds.

• If a fire alarm was sounding,

“Sounder Silenced” is displayed until

the system is reset. *

• Determine why the sounders, if

any, were activated.

• Correct the cause.

• If a fire alarm was sounding,

correct the cause and press

[System Reset] or [#][4][7] to

reset the system.

RF3341 Keypad [PIN][#] • The LED flashes indicating a signal

was sent to your security system.

• All sounders are silenced.

• All zones are disarmed.

• Determine why the sounders, if

any, were activated.

• Correct the cause.

• If a fire alarm was sounding,

correct the cause and press

[System Reset] or [#][4][7] to

reset the system.

RF3332/RF3332E

RF3334/RF3334E

Press DISARM

(unlock) button

• The LED flashes indicating a signal

was sent to your security system.

• All sounders are silenced.

• All zones are disarmed.

• Determine why the sounders, if

any, were activated.

• Correct the cause.

• If a fire alarm was sounding,

correct the cause and press

[System Reset] or [#][4][7] to

reset the system.

* Text Keypad only

Note: When in Commercial Fire Mode, enter [PIN][#] a second time on a text or LED keypad to

locate the fire zone number(s) in alarm.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments

Bosch DS7400XiV4-EXP User Manual Page 12

Comments to this Manuals

Related products and manuals for Security access control systems Bosch DS7400XiV4-EXP