Bosch VideoJet 8008 User Manual download pdf (Page 119)

VideoJet 8008 | Installation and Operating Manual

EN | 119

Bosch Security Systems | 2005-06 | V2.0 Maintenance and upgrades

Maintenance and upgrades 7

Testing the network connection

The ping command can be used to check the connection between two IP

addresses. This allows you to test whether a device is active in the network.

– Open the DOS command prompt.

– Type ping followed by the IP address of the device.

If the device is found, the response appears as " Reply from ... ", followed

by the number of bytes sent and the transmission time in milliseconds.

Otherwise, the device cannot be accessed via the network. This might be

because

] The device is not properly connected to the network. Check the cable

connections in this case.

] The device is not correctly integrated into the network. Check the

IP address, subnet mask and gateway address.

Restart (reset)

If necessary, you can restart the VideoJet 8008, for example if the unit is no

longer responding. All settings are retained.

– In the address bar of the web browser, enter /reset after the unit IP

address (for example 192.168.0.80/reset).

A new page appears containing the message going to reset Reconnecting in

... seconds, indicating the time until the connection will automatically be re-

established.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 135 136

No comments

Bosch VideoJet 8008 User Manual Page 119