Bosch MIC SERIES 500 CAMERA 500 User Manual download pdf (Page 16)

16 en | Mounting MIC Series 500 Camera

F.01U.173.601 | 2.0 | 2010.11 User’s Manual Bosch Security Systems, Inc.

3. Grasp the lower camera body beneath the pan body joint and then carefully twist the

upper camera body clockwise until the camera body has rotated 180° around, canting the

top part of the camera to the 45° angle. Ensure that the securing bolt holes are aligned.

Figure 4.6 Canting in progress

4. Carefully replace and tighten the pan body securing the supplied (MIC-DCA, MIC-SCA,

MIC-WMB) bolts. Ensure not to damage the paint work on the camera.

Figure 4.7 Camera canted

5. The MIC 500 Series Camera is now ready to be installed and configured.

The following graphic shows the various positions of the MIC 500 Series Camera. See the

table below for the descriptions.

Figure 4.8 MIC 500 Series Cameras (From left to right: Canted full frontal view; Upright full frontal view;

Upright side view; Canted side view)

NOTICE!

Installation should be made by qualified service personnel and conform to the National

Electrical Code and applicable local codes. Ensure a strong safety chain is used to secure the

MIC 500 Series Camera to prevent any danger of dropping the product during installation.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

No comments

Bosch MIC SERIES 500 CAMERA 500 User Manual Page 16