Bosch DIP-7082-8HD Installation Manual download pdf (Page 14)

Chassis setup and maintenance

This chapter covers the steps required to install components and perform maintenance on the

chassis.

Caution!

Review the warnings and precautions listed in the manual before setting up or servicing this

chassis.

See also:

– Safety precautions, page 5

– Rack precautions, page 24

– General system precautions, page 25

Removing the chassis cover

To remove the chassis cover:

Remove the two screws on each side of the cover, which secure the cover to the chassis.

2. Press the release tabs to remove the cover from the locked position. Press both tabs at

the same time.

3. Once the top cover is released from the locked position, slide the cover toward the rear

of the chassis.

4. Lift the cover off the chassis.

Notice!

Except for short periods of time, do NOT operate the server without the cover in place. The

chassis cover must be in place to allow proper airflow and prevent overheating.

3.1

14 en | Chassis setup and maintenance DIVAR IP 7000 2U

2013.09 | V2 | DOC Installation Manual Bosch Sicherheitssysteme GmbH

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

No comments

Bosch DIP-7082-8HD Installation Manual Page 14