Bosch DIP-7082-8HD Installation Manual download pdf (Page 24)

Rack installation

This chapter provides a quick setup checklist to get your chassis up and running. Following

these steps in the order given should enable you to have the system operational within a

minimum amount of time.

Unpacking the system

You should inspect the box the chassis was shipped in and note if it was damaged in any way.

If the chassis itself shows damage, file a damage claim with the carrier who delivered it and

notify the respective Bosch RMA desk.

You will also need it placed near at least one grounded power outlet.

Due to the weight of the system: After opening the top of the shipping box, one person should

stand at either end and lift the disk array out together.

Be sure to read the safety precautions.

Preparing for setup

The box the system is shipped in includes a rack mount kit, which you will need to install the

system into the rack.

Follow the steps in the order given to complete the installation process in a minimum amount

of time. Read this section before you begin the installation procedure outlined in the sections

that follow.

Choosing a setup location

–

Situate the system in a clean, dust-free area that is well ventilated. Avoid areas where

heat, electrical noise and electromagnetic fields are generated. Place the system near a

grounded power outlet.

– Leave approximately 25 inches clearance in front of the rack to be able to open the front

door completely.

– Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient

airflow and ease in servicing.

– Install the system only in a Restricted Access Location (dedicated equipment rooms,

service closets and the like).

Notice!

This product is not suitable for use with visual display work place devices acccording to §2 of

the the German Ordinance for Work with Visual Display Units.

Rack precautions

Warning!

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special

precautions to ensure that the system remains stable. The following guidelines are provided

to ensure your safety:

– Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor

with the full weight of the rack resting on them.

–

In single rack installations, attach stabilizers to the rack.

4.1

4.2

4.2.1

4.2.2

24 en | Rack installation DIVAR IP 7000 2U

2013.09 | V2 | DOC Installation Manual Bosch Sicherheitssysteme GmbH

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Comments to this Manuals

No comments

Bosch DIP-7082-8HD Installation Manual Page 24

Comments to this Manuals