Bosch WAN20050IL User Manual download pdf (Page 34)

en Cleaning and maintenance

34

Note: To prevent unused detergent

from flowing straight into the drain

during the next wash, pour 1 litre of

water (without detergent) into

compartment II and start the Drain/

Empty programme. Do the next wash

as usual.

Drain hose at the siphon is

blocked

1. Switch off the appliance. Disconnect

the mains plug.

2. Loosen the hose clamp. Carefully

remove the drain hose; residual

water may leak out.

3. Clean the drain hose and siphon

connecting piece.

4. Reattach the drain hose and secure

the connection using the hose

clamp.

Filter in the water supply is

blocked

:Warning

Risk of electric shock!

The Aqua-Stop contains an electric

valve. There is a risk of electric shock if

you immerse the Aqua-Stop safety valve

in water. Do not immerse the safety

valve in water.

First, reduce the water pressure in the

supply hose:

1. Turn off the tap.

2. Select any programme (except

Rinse/Spin/Drain/Empty).

3. Press the Start Reload A button.

Allow the programme to run for

approximately 40 seconds.

4. Turn the programme selector to the

off position. Disconnect the mains

plug.

5. Clean the filter on the tap:

Disconnect the hose from the tap.

Clean the filter with a small brush.

6. For standard and Aqua-Secure

models, clean the filter on the rear of

the appliance:

Remove the hose from the rear of

the appliance.

Use pliers to remove the filter and

then clean it.

7. Insert the filter, connect the hose and

check for leaks.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments