Bosch WAU28460MY Installation Manual download pdf (Page 40)

en Faults and what to do about them

40

Filter in the water supply is

blocked

First, reduce the water pressure in the

supply hose:

1. Turn off the tap.

2. Select any program (except 0 Spin).

3. Press the A Start/Reload button.

Allow the program to run for

approximately 40 seconds.

4. Turn the program selector to off

position.

5. Pull out the mains plug.

6. Clean the filter on the tap:

Disconnect the hose from the tap.

Clean the filter with a small brush.

7. For standard and Aqua-Secure

models, clean the filter on the rear of

the appliance:

Remove the hose from the rear of

the appliance.

Use pliers to remove the filter and

then clean it.

8. Insert the filter, connect the hose and

check for leaks.

3 Faults and what to do

about them

Faults and what to do about them

Emergency release

(depending on the model)

e.g. in the event of a power outage

Note: The programme will continue

running when the power supply has

been restored.

:Warning

Risk of scalding!

When you are washing at high

temperatures, there is a risk of scalding

if you come into contact with detergent

solution and laundry.

If possible, leave it to cool down.

:Warning

Risk of injury!

You may injure your hands if you reach

into the drum while it is turning.

Do not reach into the drum when it is

turning. Wait until the drum has stopped

turning.

Caution!

Water damage

Any escaping water may cause water

damage. Do not open the washing

machine door if water can be seen

through the glass.

If the laundry has to be removed, the

washing machine door can be opened

as follows:

1. Switch off the appliance.

2. Disconnect the mains plug.

3. Drain the water. ~ Page 38

4. Pull the emergency release

downwards with a tool and release.

The washing machine door can now

be opened.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments