Bosch WAU28460MY Installation Manual download pdf (Page 41)

Faults and what to do about them en

Information on the display panel

Faults and what to do about them

Display Cause/Remedy

Õ ■ Flashes fast + warning signal: The door was opened and the water level is

too high. Close the door, continue the programme with A Start/Reload button

or select 0 Spin programme.

■ Flashes slowly: The door lock temperature is too high to open the door. Wait

approx. 30 seconds until the door lock temperature cools down.

r ■ Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean

the water inlet filter.

If an additional water filter has been installed (depending on the model), check

for contaminants and clean if required ~ separate installation and cleaning

instruction for water filter.

Water hose kinked or blocked?

■ Lights up (low water pressure): For information only. This will not affect the

programme progress. The programme duration is extended.

E:18 Drain pump blocked; clean the drain pump. Clean the drainage hose on the siphon.

Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the dis-

play appears again, call customer services.

Faults Cause/Remedy

Water is leaking from the

machine.

■ Attach the drain hose correctly or replace it.

■ Tighten the screw connection of the drain hose.

The machine is not filling

with water.

Detergent is not being dis-

pensed.

■ Have you pressed the A Start/Reload button?

■ Is the tap turned on?

■ Could the filter be clogged? Clean the filter ~ Page 40

Note: If an additional water filter has been installed (depending on the

model), check for contaminants and clean if required ~ separate installa-

tion and cleaning instruction for water filter.

■ Is the supply hose kinked or trapped?

The door cannot be

opened.

■ The safety function is activated. Stop the program?

■ Is the E childproof lock activated? Deactivate.

■ Is “- - - -” selected (Rinse Stop = no final drain)?

■ Can the door only be opened by the emergency release?

The program will not

start.

■ Have you pressed the A Start/Reload or ñ Finished In button?

■ Is the door closed?

■ Is the E childproof lock activated? Deactivate.

The drum briefly jerks or

judders after the program

has started.

Not a fault – the internal motor test may cause the drum to jerk or judder briefly

when the wash program starts.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Bosch WAU28460MY Installation Manual Page 41

Comments to this Manuals

Related products and manuals for Washing machines Bosch WAU28460MY