Bosch DHL505B Installation Manual download pdf (Page 20)

Activated carbon filter

5. Insert the activated carbon filter at the

rear, fold up and lock in the middle with

the wing nut. If the spacer rail has been

removed, it must be re-installed.

6. Re-insert the two filter cartridges.

Removing the activated carbon filter:

❑ The activated carbon filter is removed in

reverse sequence.

Changing the activated carbon filter:

If used normally (1 to 2 hours daily), the

activated carbon filter should be changed

approx. once a year.

Activated carbon filters can be purchased

from SPECIALIST OUTLETS (see optional

accessories on the last page).

Use original filters only. This will ensure

optimum performance.

Disposing of the old activated carbon

filter:

Activated carbon filters do not contain any

pollutants. They can be disposed of e.g. as

residual waste.

Extractor hoods with two filter cartridges:

1. Remove the filter cartridge.

❑ See grease filter.

2. Insert the screw through the wing nut

and the sleeve and screw in the middle

screw in the false bottom (required only

during the initial installation). Screw,

sleeve and wing nut are enclosed with

the activated carbon filter.

3. Using a screwdriver, press in the two

lugs on the false bottom. If a spacer rail

has been installed, it must be removed.

4. Tape over the activated carbon filter with

the enclosed sealing strip.

5750.197 457+458.Bo/Si.qxd 24.01.2005 10:08 Uhr Seite 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

No comments

Bosch DHL505B Installation Manual Page 20