Bosch B36ET71SN Owner's Manual download pdf (Page 21)

 Put on the base panel (do not screw on) and measure

the difference in depth Y between the base panel and

toe kick panel of the adjacent furniture.

 Remove the base panel.

 Loosen the brackets for attaching the base panel and

push in all the way.

 Pull out the brackets by the measured amount Y.

 Screw the brackets tightly.

 Attach the base panel.

16. Attaching stainless steel front panel

to the freezer compart-ment drawer

 Hang stainless steel front panel over the threaded bolts.

 Lift bottom of stainless steel front panel and push the

fixing brackets down over the screws.

 When the freezer compartment door is closed, check

the depth of the stainless steel front panel with respect

to the adjacent furniture front panels.

If the depth alignment is correct, tighten the screws on

the fixing brackets.

 Screw nuts onto the threaded bolts on top of the door.

Do not tighten yet.

 Check lateral alignment of the stainless steel front panel.

If the lateral alignment is correct, tighten the nuts.

NOTE

If required, the toe kick panel can be screwed to the

base panel. There are screw holes in the base panel

near the Velcro.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

No comments

Bosch B36ET71SN Owner's Manual Page 21