Bosch 1617EVSPK Specifications download pdf (Page 13)

desired, until the final depth (lowest step or flat)

is reached. Steps progress by 1/8” increments.

To be certain that your depth settings are as

desired, you may want to make test cuts in

scrap material before beginning work.

FINE ADJUSTMENT

The RA1166 plunge base is equipped with a

fine adjustment system that allows you to micro

adjust the plunge depth of the router bit for

superior routing accuracy.

Each complete revolution of the fine adjustment

stop adjusts the plunging depth by 1/32”, and

each of the four indicator marks on the knob

represents 1/128”. One of the four tick marks is

larger than the other to indicate a complete

revolution. A reference indicator line is built in

to the depth rod.

To use the fine adjustment knob, once the

depth rod and turret have been set, check the

final depth setting and fine-adjust as follows:

To micro-increase the plunge depth, raise the

fine adjustment stop by turning it counter-

clockwise by the desired amount.

To micro-reduce the plunge depth, lower the

fine adjustment stop by turning it clockwise by

the desired amount.

Notes:

• When micro-adjusting the plunge depth, it is

more convenient to move the fine adjustment

stop up than down. Before setting the depth

rod and turret, make sure the fine adjustment

stop has been turned several revolutions

down from its top position so that it can be

adjusted upward.

• The fine adjustment stop cannot be use to

reduce the plunge depth when the depth rod

is already touching the depth stop turret. The

router must be raised before such an

adjustment can be made.

-13-

2

1

0

IN

50

40

30

20

10

0

MM

FIG. 14

DEPTH INDICATOR

KNOB

DEPTH

INDICATOR

DEPTH ROD

DEPTH STOP

TURRET

DEPTH ROD FINE

ADJUSMENT KNOB

BM 2610908996 5/03 5/20/03 9:06 AM Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Comments to this Manuals

No comments