Bosch 1617EVSPK Specifications download pdf (Page 14)

-14-

ROCKER “ON/OFF” SWITCH

Your tool can be turned “ON” or “OFF” by the

rocker switch located on the motor housing.

One side of the switch is marked “I” for “ON“,

and the other side of switch is marked “O” for

“OFF“. Also the edge of switch displays red

when switch is in the “ON“ position.

TO TURN THE TOOL “ON”: Push the side of

the switch marked “I”.

TO TURN THE TOOL “OFF”: Push the side of

the switch marked “O”.

Always hold the router off the work when

turning the switch on or off. Contact the work

with the router after the router has reached full

speed, and remove it from the work before

turning the switch off. Operating in this manner

will prolong switch and motor life and will

greatly increase the quality of your work (Fig. 1).

ROCKER POWER "ON-OFF" WITH TRIGGER

SWITCH AND "LOCK-ON"BUTTON

(Models 1618 & 1618EVS only)

The power is switched "ON" by the rocker

switch located on the top of the motor housing

as described above. Now your tool can be

turned "ON" or "OFF" by squeezing or

releasing the trigger. Your tool is also equipped

with “Lock-ON” button located just above the

trigger that allows continuous operation without

holding the trigger (Fig. 2).

TO LOCK SWITCH ON: Squeeze trigger,

depress button and release trigger.

TO UNLOCK THE SWITCH: Squeeze trigger

and release it without depressing the “Lock-

ON” button.

If the “Lock-ON” button is

continuously being

depressed, the trigger cannot be released.

On models 1617 & 1618 hold the tool with both

hands while starting the tool, since torque from

the motor can cause the tool to twist.

SOFT START FEATURE

(Models 1617EVS & 1618EVS only)

Electronic feedback control minimizes torque

twist customary in larger routers by limiting the

speed at which motor starts.

ELECTRONIC VARIABLE SPEED CONTROL

(Models 1617EVS & 1618EVS only)

The electronic speed control feature allows

motor speed to be matched to cutter size and

material hardness for improved finish, extended

bit life, and higher performance. Speed

changes are achieved by rotating Control Dial

RIGHT to increase speed, LEFT to decrease as

indicated on housing (Fig. 1). Speed may be

changed while tool is on. The reference

numbers on the dial facilitate re-setting control

to desired speed.

The speed chart indicates the relationship

between settings and application, exact

settings are determined by operator experience

and preference. The bit manufacturer may also

have a speed recommendation.

CONSTANT RESPONSE™ CIRCUITRY

(Models 1617EVS & 1618EVS only)

The router's Constant Response™ Circuitry

monitors and adjusts power to maintain the

desired RPM for consistent performance and

control.

!

WARNING

DIAL

SETTING RPM APPLICATION

1 8,000

2 13,500

3 16,500

4 20,000

5 21,500

6 25,000

}

}

Nonferrous metals,

larger diameter bits,

and cutters

Softwoods, plastics,

counter tops, smaller

diameter bits, and

cutters

BM 2610908996 5/03 5/20/03 9:06 AM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Comments to this Manuals

No comments