Bosch SN350-34C-RT Installation Guide download pdf (Page 7)

Operation

2-3 Drops

of Air Tool

Lubricant

FIG. 2

Lubrication

If the tool is not used with an in-line lubrication system on

the air supply it is necessary to periodically lubricate the tool

with air tool lubricant.

Under low use, lubricate once a day. Under heavy use,

lubricate twice a day. To lubricate, insert 2-3 drops of

lubricant into the air supply fitting attached to the tool handle

- FIG 2. Using to much oil will cause it to collect in the tool

and be noticeable in the exhaust.

Use only the air tool lubricants supplied

with the tool or specified by BOSCH. Do

not use other lubricants as they may damage the tool.

Do not use detergent oil, WD-40, transmission fluid, motor

oil, or other lubricants not specifically designated as air tool

lubricants. These lubricants will cause accelerated wear to

the seals, o-rings, and bumpers in the tool, resulting in poor

tool performance and frequent maintenance.

BOSCH recommended lubricants: 10W Pneumatic Tool Oil,

Fuchs Air Lube 10W/NR.

Nail Loading

Always load nails into the tool's magazine

before the air supply is connected.

Connecting the air supply after loading nails reduces the risk

of unintentionally driving a nail and injuring yourself or

someone else.

1. Pull the nail follower back until it latches - FIG 3.

When loading the tool's magazine, check

that the nail follower slides smoothly by

pulling with finger. If not smooth, nails can be driven at

irregular angle.

2. Insert appropriate collated nail strips into loading slot on

top of magazine. See tool specifications to determine

appropriate nail sizes and angles.

Do not load strips that contains fewer than five (5) nails -

Fig 4. Do no load more than two strips of nails.

Note: The SN350-34C features a nail follower lockout that

will prevent the tool from firing when approximately 5 nails

are left in the magazine.

Set heads of overlapped nails as shown in FIG 5.

Nail

Follower

FIG. 3

WARNING

FIG. 4 FIG. 5

BM 2610957373 10-08:BM_2610957373 10-08.qxp 1/6/12 1:08 PM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 41 42

Comments to this Manuals

No comments

Bosch SN350-34C-RT Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Power tools Bosch SN350-34C-RT