Bosch SN350-34C-RT Installation Guide download pdf (Page 8)

Use only the nails meeting the criteria

listed in the “Specification” section of this

manual. Nails not identified for use with this tool can cause

the tool to malfunction and result in the risk of injury and/or

tool damage.

3. Pull the nail follower a second time to release latch, and

carefully allow the feeder to slide forward until it makes

contact with the nails - FIG 6.

Ensure that the head of the tail nail is set under the nail

stopper of the nail follower - FIG 7.

Watch for pinch points with the follower.

Never place any part of your body in a

pinch point area. When loading nails consider where your

hand is located. If it is within a pinch point, strongly consider

an alternative position. Injuries occur when hands or fingers

are between moving and stationary parts during the pinching

movement.

Connecting Air Supply

Never use oxygen or other bottled gases

as a power source. Explosion may occur.

Combustible gases and other bottled gases are dangerous

and may cause the tool to explode.

Never connect the tool to an air source

that is capable of producing air pressure

exceeding 200 PSI. Excessive pressure can cause

abnormal operation or cause the tool to burst, resulting in

personal injury.

Use only clean, dry, regulated compressed air within the

pressure range as marked on the tool. The correct pressure

is the lowest pressure that will do the job.

Before connecting the tool to the air supply, check the air

compressor regulator gauge to be sure it is functioning

properly, and that the air pressure is within the operational

range of the tool, 60-120 psi.

Do not exceed maximum recommended

air pressure marked on the tool. Verify

prior to using the tool that the air source has been adjusted

within the rated air-pressure range. Be sure the air pressure

gauge is operating properly and check it at least twice a day.

Tools operated in excess of their maximum pressure rating

may operate abnormally or burst resulting in personal injury

To connect the tool to the compressor only use pneumatic air

hoses that meet the following criteria:

• Minimum hose pressure rating, 200 psi

• Minimum hose inner diameter, 3/8 in.

• Maximum hose length, 100 ft.

To connect the air supply:

1. Snap the air hose onto the quick connector - FIG 8.

2. Check for air leakage. If leakage is noted, cease using the

tool immediately and contact your BOSCH service center.

3. Be sure the air pressure gauge is operating properly and

check it at least twice a day.

FIG. 8

FIG. 7

Nail

Stopper

Tail

Nail

Operation

WARNING

FIG. 6

WARNING

BM 2610957373 10-08:BM_2610957373 10-08.qxp 1/6/12 1:08 PM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 41 42

Comments to this Manuals

No comments

Bosch SN350-34C-RT Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Power tools Bosch SN350-34C-RT