Bosch LTC 8500 Instruction Manual download pdf (Page 69)

General Information

EN | 59

After entering the mode, the joystick is moved right or left to select the character to

be changed. The selected character is identified by a box with a question mark

inside it. The first line of the video monitor display indicates the code number of the

character selected. Move the joystick up or down to step through the Character

ROM Table, or enter the character's number identified in the tables via the numeric

keypad, then press [Enter]. Once the monitor title has been set, press [Enter] to store

it to memory. If using the LTC 8555 Series keyboard, press [User] to exit the mode.

The user may select between this monitor message and the status display by using

the User 5 Function described above.

User Function 18 - Print Sequence

Use this function to print the contents of a programmed sequence. Use the joystick

to select the desired sequence, then press [Enter] to print it to the printer port. Only

those sequences currently existing in memory will be shown in the list. If using the

LTC 8555 Series keyboard, press [User] to exit.

User Function 19 - Select Alarm Response

Use this function to reset the system alarm configuration tables to one of these pre-

defined alarm response modes: BASIC, AUTOBUILD, or SEQUENCE & DISPLAY.

Move the joystick up or down to select the desired mode, then enter your user pass-

word on the numeric keypad. Press [Enter] to update the alarm system. If using the

LTC 8555 Series keyboard, press [User] to exit.

NOTE Existing alarm configuration data will be lost when mode is changed.

User Function 20 - Select Printer Verbosity

Use this function to select between print modes; Limited Printing and Full Printing.

This selection determines the amount of information printed during alarm process-

ing. Both modes print alarm activation and deactivation messages, but Full Printing

goes into much more detail. Use the joystick to select the desired mode, then press

[Enter]. If using the LTC 8555 Series keyboard, press [User] to exit without chang-

ing the print mode.

User Function 21 - Designate Alarm Monitor Type

Use this function to designate the monitor currently controlled by the keyboard as

either a STEP monitor or a REVIEW monitor. This function can only be used in the

predefined SEQUENCE & DISPLAY alarm response mode (see ALARM INFORMA-

TION section) to select which monitor is the STEP (also called SEQUENCE) moni-

tor, and which is the REVIEW (also called DISPLAY) monitor. To designate a

monitor as the STEP or REVIEW monitor, enter User Function 21, then move the

joystick up or down to select the monitor type. Enter your password on the key-

board and press [Enter]. If using the LTC 8555 Series keyboard, press [User] to exit.

After selecting new STEP and REVIEW monitors, the previous ones may be dis-

armed (Arm/Disarm Monitor instructions).

User Function 22 - Select Control Code Format

This function designates whether variable speed pan/tilt and zoom commands are

enabled (Factory Default Setting). In most cases, there is no need to disable this

function. Move the joystick up or down to select the desired setting, then press

[Enter]. If using the LTC 8555 Series keyboard, press [User] to exit.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 103 104

Comments to this Manuals

No comments

Bosch LTC 8500 Instruction Manual Page 69

Comments to this Manuals

Related products and manuals for Security access control systems Bosch LTC 8500