18 en | Operation via the browser Camera Browser Interface
AM18-Q0635 | v5.6 | 2013.01 Software manual Bosch Security Systems
Pre-position
To move the camera to a pre-position, click one of the buttons
numbered one to six.
To store the current position of the camera in a pre-position:
1. Position the camera.
2. Enter a pre-position number.
3. Click Set.
3.1.4 View Control ROI
When the stream 2 encoder stream is set for Region of Interest
(ROI), a specific type of View Control panel is activated.
Refer to Section 9.3 Encoder Regions, page 66 for more
information on setting up stream 2. (When encoder stream 2 is
set for dual ROI, open the camera in a second browser window
to set up the second ROI on stream 2.)
Zoom
To zoom in on a region of the stream 2 image:
Click and hold to zoom in; click and hold to
zoom out.
Click to see the full image.
Select an area
To select a particular region of the image:
1. Click and hold the arrows to move up and down, and from
side to side through the image.
2. Click and hold the center area to move in all directions.
Comments to this Manuals