Bosch GWS 6-115E Operations Instructions download pdf (Page 22)

English–7

1 619 P01 967 • 20.6.06

Rubber Sanding Plate

f For operations with the rubber sanding plate

14 or with the cup brush/wheel brush/flap

disc, always mount the hand guard 13.

See graphics page for the mounting sequence.

Screw on the round nut 16 and tighten with the two-

pin spanner.

Cup Brush/Disc Brush

f For operations with the rubber sanding plate

14 or with the cup brush/wheel brush/flap

disc, always mount the hand guard 13.

See graphics page for the mounting sequence.

The cup brush/disc brush must be able to be screwed

onto the grinder spindle until it rests firmly against the

grinder spindle flange at the end of the grinder spindle

threads. Tighten the cup brush/disc brush with an

open-end spanner.

Quick-clamping Nut

For convenient changing of grinding tools without the

use of additional tools, you can use the quick-clamp-

ing nut 11 instead of the clamping nut 10.

f The quick-clamping nut 11 may be used only

for grinding or cutting discs.

Use only a flawless, undamaged quick-clamp-

ing nut 11.

When screwing on, pay attention that the side

of the quick-clamping nut 11 with printing does

not face the grinding disc; the arrow must point

to the index mark 18.

Lock the grinder spindle

with the spindle lock but-

ton 1. To tighten the quick-

clamping nut, firmly turn

the grinding disc in clock-

wise direction.

A properly attached,

undamaged quick-clamp-

ing nut can be loosened by

hand when turning the

knurled ring in anticlock-

wise direction.

Never loosen a tight

quick-clamping nut with

pliers. Always use the

two-pin spanner. Insert

the two-pin spanner as

shown in the illustration.

Approved Grinding Tools

All grinding tools mentioned in these operating

instructions can be used.

The permissible speed [rpm] or the circumferential

speed [m/s] of the grinding tools used must at least

match the values given in the table.

Therefore, observe the permissible rotational/cir-

cumferential speed on the label of the grinding tool.

Rotating the Machine Head

f Before any work on the machine itself, pull

the mains plug.

The machine head can

be rotated with

respect to the

machine housing in

90° steps. In this man-

ner, the On/Off switch

can be brought into a

more convenient han-

dling position for spe-

cial working situations,

e. g., cutting opera-

tions with the cutting

guide /cut off stand or

for left-handed per-

sons.

Completely unscrew the four screws. Rotate the

machine head carefully, without removing it from

the housing, to the new position. Screw in and

tighten the four screws again.

max.

[mm] [mm]

D b d [rpm] [m/s]

115

125

22.2

11000

115

125

11000

75 30 M 14 11000 45

OBJ_BUCH-161-001.book Page 7 Tuesday, June 20, 2006 11:17 AM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 136 137

Comments to this Manuals

No comments

Bosch GWS 6-115E Operations Instructions Page 22

Comments to this Manuals

Related products and manuals for Straight grinders Bosch GWS 6-115E