Bosch TSTBM3H2CPH6W-A Installation Manual download pdf (Page 5)

6 720 220 376

Revised 02-13 Subject to change without prior notice

5TSTBM3H2CPH6W-A

WIRING

1. If you are replacing a thermostat, make note of

the terminal connections on the thermostat

that is being replaced. In some cases the wiring

connections will not be color coded. For

example, the green wire may not be connected

to the G terminal.

2. Loosen the terminal block screws. Insert wires

then retighten terminal block screws.

Caution

All components of the control system and the

thermostat installation must conform to

Class II circuits per the NEC Code.

Wire specications

Use shielded or non-shielded 18 - 22 gauge

thermostat wire.

BASE MODULE SUBBASE

INSTALLATION AND WIRING

Horizontal mount

Vertical mount

W1/E

Vertical mount

For vertical mount put one screw top and one

screw bottom. For horizontal mount put one screw

left and one screw right.

Caution

Wire the base module’s subbase the same

way you would wire a hardwired thermostat

subbase.

Caution

To establish communication from the base

module to master thermostat, refer to the

directions in the TSTBM3H2CPH6W-A

Thermostat-Base Module Communication

setup procedure below in this manual.

BASE MODULE—BASEMENT

INSTALLATION

Wireless Range

Range between the TSTBM3H2CPH6W-A and the

base module is up to 100 feet with no obstructions

and up to 50 feet in standard residential metal,

brick, and concrete construction. To extend the

range try placing the base unit higher if in a

basement or further away from large metal objects.

Do not install the base module in locations:

• Where temperatures could exceed 150°F

• That could be exposed to rain or snow

• That could be exposed to freezing conditions

• That are behind a chimney

• Where high moisture is possible

Caution

The base module is NOT water or

weatherproof and should only be installed in a

conditioned space.

BASE MODULE—ATTIC INSTALLATION

Attic installation of the base module should be

avoided. Instead, locate a closet near the air

conditioning unit, then mount the base module high

on the wall inside the closet or on the ceiling of the

closet. This location will insure the base module is

below the 150ºF maximum ambient temperature

specication.

For vertical mount put one screw top and one screw

bottom. For horizontal mount put one screw left

and one screw right.

Failure to disconnect the power before

beginning to install this product can cause

electrical shock or equipment damage.

Caution

Mercury Notice: All Bosch thermostats are

mercury free. However, if the product you are

replacing contains mercury, dispose of it

properly. Your local waste management

authority can give you instructions on recycling

and proper disposal.

Base Module—Basement Installation

Installation

1 2 3 4 5 6 7 8 9 10 ... 31 32

Comments to this Manuals

No comments

Bosch TSTBM3H2CPH6W-A Installation Manual Page 5

Comments to this Manuals