Bosch WAU28460MY Installation Manual download pdf (Page 34)

en Operating the appliance

34

Notes

■ Dilute viscous fabric softener

and fabric conditioner with water.

This will prevent blockages.

■ Be careful when opening the

detergent drawer while the appliance

is running.

Measuring aid A* for liquid detergent

* Depending on the model

Position the measuring aid for

measuring the correct amount of liquid

detergent:

1. Pull out the detergent drawer. Insert

the liquid detergent container into

dispenser II for main wash.

2. Pour liquid detergent into liquid

detergent container and do not

exceed the Maximun mark.

3. Reinsert the drawer.

Note: Do not use the viscous liquid

detergent.

Starting the programme

Press the A Start/Reload button. The

indicator lamp lights up and the

program starts.

The display panel shows the Ready in

time while the program is running or the

program duration and the program

progress symbols once the wash cycle

has started.

Note: Foam detection

If the Å symbol also lights up in the

display panel, the washing machine has

detected too much foam during the

wash cycle and automatically activated

additional rinse cycles to remove the

foam.

Add less detergent to the next wash

cycle with the same load.

If you want to lock the program to

prevent it from being inadvertently

adjusted, you can select the childproof

lock as follows.

Childproof lock

(Child Lock E 3sec.)

You can lock the washing machine to

prevent the functions you have set from

being changed inadvertently. To do this,

activate the childproof lock when the

program has started.

To activate/deactivate, press and hold

the 0 rpm and ñ Finished In buttons at

the same time after the washing

program has started. Keep pressing the

two buttons for approx. three seconds.

The E symbol appears in the display

panel.

■ E lights up: The childproof lock is

active.

■ E flashes: The childproof lock is

active and the program selector has

been adjusted. To deactivate the

childproof lock, reset the program

selector to the initial program. The

symbol lights up again.

Note: To avoid the program to

terminate, do not turn the program

selector beyond the Off position.

Note: The childproof lock remains

active after the program has ended and

the appliance is switched off. You must

always deactivate the childproof lock if

you want to start a new program.

0$;

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Comments to this Manuals

No comments