19
Trouble shooting
Trouble shooting
: Risk of injury!
Incorrect repairs may cause serious hazards. Repairs to the
appliance must only be carried out by a qualified technician. If
repairs are required, contact the after-sales service.
Fault table
Replacing the oven light bulb
If the bulb in the oven light fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from the
after-sales service or from specialist retailers. Please supply
your appliance's E number and FD number. Do not use any
other type of bulb.
: Risk of electric shock!
When replacing the cooking compartment bulb, the bulb socket
contacts are live. Before replacing the bulb, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box.
1. Pull out the mains plug or switch off the circuit breaker.
2. Open the appliance door.
3. When the oven is cold, place a tea towel inside to prevent
damage.
4. Remove the glass cover for the defective oven light in the
cooking compartment.
5. Replace the oven light bulb with one of the same type.
Voltage: 230 V;
Power: 25 W;
Thread: E14;
Temperature resistance: 300 °C
6. Put the glass cover for the oven light bulb back on.
7. Remove the tea towel and switch the circuit breaker back on
or plug the mains plug in again.
8. Switch on the oven light and check that it is working correctly.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. You can
make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
After-sales contact details for all countries can be found in the
attached after-sales service directory.
Fault Possible cause Remedy/information
The appliance does not work. The circuit breaker is faulty Look in the fuse box and check that the circuit
breaker is in working order.
Power cut Check whether the kitchen light works.
Zeros flash in the display. Power cut Reset the time.
The oven light has failed. Faulty oven light Change the oven light bulb. (See section "Replacing
the oven light")
The oven does not heat up. Faulty fuse. Check and, if required, replace the circuit breaker.
The function selector has not been set. Set the function selector.
All dishes that are prepared in the
oven burn within an extremely
short period of time.
Faulty thermostat Call the after-sales service.
The door panel steams up when
the oven is hot.
Normal occurrence; caused by the dif-
ference in temperature
Not possible; this has no effect on oven performance.
E no.
FD no.
After-sales service
O
Comments to this Manuals