Bosch 3915 User Manual download pdf (Page 15)

15.

Adjustments

Miter Scale

Indicator Adjustment

1. Rotate table to 0° position and lock in place.

2. Raise the head assembly to the full-up position.

3. Loosen the Phillips screw that holds the indica-

tor in place (Figure 12).

4. Position the indicator to align with the 0° miter

mark. Tighten the screw.

Figure 12. Miter Scale Adjustment

Miter Scale

Indicator

Adjustment

Screw

6/12

22.5

2/12

/12

6/1

22.5

31.6

/12

0° Mark

Blade Square to Fence

1. Make sure head assembly is pulled forward near

the center of the table and slide rail lock knob is

tightened.

2. Lower the head assembly, pull the lock pin out

and rotate it 90°, rotate to lock in the

lower position. Make sure table is in 0° detent

and tighten miter lock knob. Place a combination

square against the fence and next to the blade as

illustrated. Locate the square properly so it does

not contact the tooth of saw blade. The saw

blade should contact the full length of the square

(Figure 10).

3. If blade does not contact the square, follow the

fence alignment procedure.

Figure 10. Blade Square to Fence

Fence Alignment

a. The head assembly should remain in lowered

position.

b. Use hex wrench (supplied) and loosen three

(3) hex cap screws behind fence (Figure 11).

c. Adjust fence until blade and the fence has full

contact with the square.

d. Tighten hex cap screws.

Figure 11. Fence Adjustment

Hex Cap

Screws

Hex Cap

Screw

Fence

Hex "L" Wrench

Fence

Combination Square

Blade

BOSCH

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 103 104

Comments to this Manuals

No comments

Bosch 3915 User Manual Page 15

Comments to this Manuals

Related products and manuals for Power saws Bosch 3915