Bosch 3915 User Manual download pdf (Page 17)

17.

Installation

To avoid injury always observe the

following:

● Unplug electric cord. Before transporting the

saw, rotate head assembly to 45° right miter,

lock into detent, pull the head assembly com-

pletely forward toward you, tighten the slide rail

lock knob and lock the head assembly in the

lowered position.

● To avoid back injury, hold the tool close to your

body when lifting. Bend your knees so you can

lift with your legs, not your back. Lift by using

the cast-in carry handles at each side of the bot-

tom of the base.

● Never carry the tool by the slide rails, this

may cause blade misalignment.

● Never carry the miter saw by the power cord or

the operational handle. Attempting to lift or

carry the tool by the power cord will damage the

insulation and the wire connections resulting in

electric shock or fire.

● Observe the position of the saw. People

standing behind it could be injured by thrown

debris.

● Place the saw on a firm, level surface where

there is plenty of room for handling and proper-

ly supporting the workpiece.

● Bolt, nail or clamp the saw to its support.

Be careful not to over drive nail

or over torque the bolt. This could

crack foot or damage base.

Workbench

Mount the saw using either the four bolt holes (7/16")

or the four nail holes to the workbench (Figure 15).

Check for clearance to the left and right of the saw.

Figure 15. Workbench Mounting

1. Each of the four mounting holes should be bolt-

ed securely using 7/16" bolts, lock washers, and

hex nuts (not included).

2. Locate and mark where the saw is to be mount-

ed.

3. Drill four (4) 7/16" diameter holes through work-

bench.

4. Place the slide compound miter saw on the

workbench aligning holes in base with holes

drilled in workbench. Install bolts, lock wash-

ers and hex nuts.

Supporting surface where saw is to be mounted

should be examined carefully after mounting to insure

that no movement can occur during use. If any tipping

or walking is noted, secure the workbench or stand

before operating the slide compound miter saw.

BOSCH

Bolt Holes

Bolt Hole

Nail Holes

Nail Hole

Bolt Hole

Nail Hole

Mounting Applications

WARNING

CAUTION

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 103 104

Comments to this Manuals

No comments

Bosch 3915 User Manual Page 17

Comments to this Manuals

Related products and manuals for Power saws Bosch 3915