Bosch 3915 User Manual download pdf (Page 28)

28.

Saw Operations

Crown Molding Laying Flat on Table

Follow these instructions for cutting crown

molding:

1. Set the bevel and miter angles using Chart 1

below. Tighten the miter lock knob and the

bevel lock handle (Figure 34).

2. Position molding on saw table. Use the chart

below for correct position. Clamp workpiece in

place using the quick clamp.

Use clamping position that does not

interfere with operation. Before

switching on, lower head assembly to make sure

clamp clears guard and head assembly.

3. Follow procedures for either chop cut or slide cut

(see page 23).

4. Wait until blade comes to a complete stop

before returning head assembly to the raised

position and/or removing workpiece.

NOTE: ALWAYS TAKE A TEST CUT USING

SCRAP TO CONFIRM CORRECT ANGLES.

Figure 34. Crown Molding Laying Flat

31.6° Miter

Workpiece

Clamp

Crown

Molding

33.9° Bevel

Arbor Lock

Chart 1: Crown Molding, Miter and Bevel Settings

WARNING

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 103 104

No comments

Bosch 3915 User Manual Page 28